Yarvik Stock 4.0.4 for Excel - Discussion

Discuss anything Scroll Excel Tablet related here.

Yarvik Stock 4.0.4 for Excel - Discussion

Postby Charlie » December 11th, 2012, 4:53 pm

Hi all,

Trashcooky kindly pointed me in the direction of this ROM & I will be flashing this soon to try out.

Trashcooky wrote:The Yarvik stock 4.0.4 works very well on the Excel, gives you additional volume soft-keys and a whopping 503 Mb system partition (it actually uses 305 MB of that) which could be useful for installing Jellybean over the top as it more than meets the minimum system partition requirement of 300 MB...


It seems to have some very good plus points according to TC, but all so has a few bad points too, depending on what you want from this ROM. This version does not have CWM built into the image (like Suggsy's 4.0.3 does and is used to get to his version of 4.0.4) and at this point I'm not sure if there is a CWM that would work with it at the mo'. Also I am presuming that it comes pre-rooted. As for what the build.prop masks the tablet at I don't know either.
" Just because you could, doesn't mean you should. "
User avatar
Charlie
Trusted Developer
Trusted Developer
 
Posts: 2471
Joined: December 28th, 2010, 8:41 pm
Location: UK
Real Name: Charlie
Scroll Version: Moto G 16GB (4.4.2 rooted)
Nexus 7 - G1 (4.4.2 rooted)
Huawei Y300 (4.1.1 rooted - TWRP)
MK809 (4.1.1 rooted - CWM)
Raspberry Pi B (512MB)

Retired: Excel (CM10) & 1st Gen' (2.1) Tab'.

Re: Yarvik Stock 4.0.4 for Excel - Discussion

Postby Charlie » December 12th, 2012, 12:28 am

Well I flashed the Yarvik Stock 4.0.4 rom via livesuite, all seems ok :)

Then I downloaded a 4.1 update (that should be done via CWM) did it via the stock recovery and it installed, rebooted and just got in a boot-loop. It was worth a go, back to the drawing board.

4.1 details: build 2012-09-13 from --> http://forum.xda-developers.com/showthr ... ?t=1821398
" Just because you could, doesn't mean you should. "
User avatar
Charlie
Trusted Developer
Trusted Developer
 
Posts: 2471
Joined: December 28th, 2010, 8:41 pm
Location: UK
Real Name: Charlie
Scroll Version: Moto G 16GB (4.4.2 rooted)
Nexus 7 - G1 (4.4.2 rooted)
Huawei Y300 (4.1.1 rooted - TWRP)
MK809 (4.1.1 rooted - CWM)
Raspberry Pi B (512MB)

Retired: Excel (CM10) & 1st Gen' (2.1) Tab'.

Re: Yarvik Stock 4.0.4 for Excel - Discussion

Postby Trashcooky » December 12th, 2012, 1:30 pm

Charlie wrote:Well I flashed the Yarvik Stock 4.0.4 rom via livesuite, all seems ok :)

Then I downloaded a 4.1 update (that should be done via CWM) did it via the stock recovery and it installed, rebooted and just got in a boot-loop. It was worth a go, back to the drawing board.

4.1 details: build 2012-09-13 from --> http://forum.xda-developers.com/showthr ... ?t=1821398


Charlie, on the CM10 update you need to do a factory reset after installation when using CWM or it simply stays on the boot animation. I also tried to install CM10 over the Yarvik ROM using stock recovery and although it recognised the file and installed it (apparently) I ended up with a permanent boot animation screen. Unfortunately, certainly as far as the Excel goes I think there are problems with this CM10 ROM. :(
If it isn't broken then don't try to fix it!
User avatar
Trashcooky
Moderator
Moderator
 
Posts: 1672
Joined: January 4th, 2012, 8:52 pm
Location: South East England
Real Name: John
Scroll Version: Original Scroll Excel 2.3 now running Sugsy 89's 4..0.4 ICS
Tabtronics Mini 8" XGA 4:3 ration JB 4.2.2
Zopo C2 Platinum 4.2.1 - 480 ppi

Re: Yarvik Stock 4.0.4 for Excel - Discussion

Postby Trashcooky » December 12th, 2012, 2:47 pm

I just discovered this Yarvik rom includes face unlock which I actually got to work a few times.
Nice gimmick but I will probably remove it as it takes up over 20MB on the system.
If it isn't broken then don't try to fix it!
User avatar
Trashcooky
Moderator
Moderator
 
Posts: 1672
Joined: January 4th, 2012, 8:52 pm
Location: South East England
Real Name: John
Scroll Version: Original Scroll Excel 2.3 now running Sugsy 89's 4..0.4 ICS
Tabtronics Mini 8" XGA 4:3 ration JB 4.2.2
Zopo C2 Platinum 4.2.1 - 480 ppi

Re: Yarvik Stock 4.0.4 for Excel - Discussion

Postby Charlie » December 12th, 2012, 6:38 pm

Just got CWM on this rom - just doing a backup test.
" Just because you could, doesn't mean you should. "
User avatar
Charlie
Trusted Developer
Trusted Developer
 
Posts: 2471
Joined: December 28th, 2010, 8:41 pm
Location: UK
Real Name: Charlie
Scroll Version: Moto G 16GB (4.4.2 rooted)
Nexus 7 - G1 (4.4.2 rooted)
Huawei Y300 (4.1.1 rooted - TWRP)
MK809 (4.1.1 rooted - CWM)
Raspberry Pi B (512MB)

Retired: Excel (CM10) & 1st Gen' (2.1) Tab'.

Re: Yarvik Stock 4.0.4 for Excel - Discussion

Postby Charlie » December 12th, 2012, 9:21 pm

Well, the CWM backup failed to complete and tried to put CM10 4.1.1 on via CWM all seemed to go OK, but on reboot I got stuck in a boot-loop.

I was however able to flash via livesuite a Yarvik 4.0.3 image that I found and then install successfully the same CWM version. CM10 installed fine via CWM this way and there was no issue with the internal SD card. Also I was able to do a successful CWM backup too.
" Just because you could, doesn't mean you should. "
User avatar
Charlie
Trusted Developer
Trusted Developer
 
Posts: 2471
Joined: December 28th, 2010, 8:41 pm
Location: UK
Real Name: Charlie
Scroll Version: Moto G 16GB (4.4.2 rooted)
Nexus 7 - G1 (4.4.2 rooted)
Huawei Y300 (4.1.1 rooted - TWRP)
MK809 (4.1.1 rooted - CWM)
Raspberry Pi B (512MB)

Retired: Excel (CM10) & 1st Gen' (2.1) Tab'.

Re: Yarvik Stock 4.0.4 for Excel - Discussion

Postby Trashcooky » December 12th, 2012, 9:36 pm

Charlie wrote:Well, the CWM backup failed to complete and tried to put CM10 4.1.1 on via CWM all seemed to go OK, but on reboot I got stuck in a boot-loop.

I was however able to flash via livesuite a Yarvik 4.0.3 image that I found and then install successfully the same CWM version. CM10 installed fine via CWM this way and there was no issue with the internal SD card. Also I was able to do a successful CWM backup too.



What size is your system partition doing it this way?
If it isn't broken then don't try to fix it!
User avatar
Trashcooky
Moderator
Moderator
 
Posts: 1672
Joined: January 4th, 2012, 8:52 pm
Location: South East England
Real Name: John
Scroll Version: Original Scroll Excel 2.3 now running Sugsy 89's 4..0.4 ICS
Tabtronics Mini 8" XGA 4:3 ration JB 4.2.2
Zopo C2 Platinum 4.2.1 - 480 ppi

Re: Yarvik Stock 4.0.4 for Excel - Discussion

Postby Charlie » December 12th, 2012, 9:41 pm

Trashcooky wrote:
Charlie wrote:Well, the CWM backup failed to complete and tried to put CM10 4.1.1 on via CWM all seemed to go OK, but on reboot I got stuck in a boot-loop.

I was however able to flash via livesuite a Yarvik 4.0.3 image that I found and then install successfully the same CWM version. CM10 installed fine via CWM this way and there was no issue with the internal SD card. Also I was able to do a successful CWM backup too.



What size is your system partition doing it this way?


More than enough at ~400mb :)

EDIT

Also you get near 2gb internal SDcard where with Suggsy's 4.1 you end up with just over 1gb (once the fix is applied)
" Just because you could, doesn't mean you should. "
User avatar
Charlie
Trusted Developer
Trusted Developer
 
Posts: 2471
Joined: December 28th, 2010, 8:41 pm
Location: UK
Real Name: Charlie
Scroll Version: Moto G 16GB (4.4.2 rooted)
Nexus 7 - G1 (4.4.2 rooted)
Huawei Y300 (4.1.1 rooted - TWRP)
MK809 (4.1.1 rooted - CWM)
Raspberry Pi B (512MB)

Retired: Excel (CM10) & 1st Gen' (2.1) Tab'.

Re: Yarvik Stock 4.0.4 for Excel - Discussion

Postby Trashcooky » December 21st, 2012, 10:30 pm

Well my Excel and I have spent the last week or so on Suggsy89's CM10 Jellybean + the XDA SD card fix + Charlie's Boot logo image re-sizer and I have suffered with ever increasing random reboots, an apparently working SD card that still refuses to allow download of additional data for Asphalt 5 and a performance which gives increasing app freezes which even despite running fix permissions in Rom Manager is so unpredictable and unreliable that I decided that for the time being at least it just had to go and I have come back once more to the Yavik 264 ROM supplied as a Yarvik 260/264 support update file on the their site.

My tablet has been spoofed/recognised by Playstore as a Nexus 7, a Tab7012, a Samsung Galaxy i9001, a Tab M701c, a Tab 97FC, an unknown allwinner A10, and an unknown Scroll Excel but of all these my personal choice at present (until JB is sorted out properly) is the Yarvik Tab264 ROM which flashes directly onto the Excel using Livesuite - but you do lose CWM, however the tablet remains rooted.

Image

After flashing the Yarvik rom: http://bit.ly/11EtzYG I find the start-up is clean and relatively fast, I can install Asphalt 5 additional data files without problem which wont download on CM10 -JB. With the Yarvik ROM apps don't suddenly freeze or misbehave, there is a more sophisticated feel about this rom which is build no 97F2-D1-H1-H01-1663.20120905 - Android Ice Cream Sandwich 4.0.4 using kernel version 3.0.8+ paco@inet#14 - build date Wed Sep5.15.56.24 CST 20102 and it is provided with an excellent ICS manual.

In fact, I have yet to find something significantly bad to say about this ROM

The only possible criticism I may have that doesn't affect the reliability or the speed of the system is that this ROM has a huge system partition of 503 MB which does rob you of some of your inbuilt storage space. I suspect this is necessary for same of the extra bells and whistle this ROM has which include Volume soft keys, a better USB notification interface and for those who like this sort of thing it has face unlock as well - however, I found this very hit and miss but I believe this is a general problem with face recognition software anyway. It also has an update option built in to the system tools which I suspect may eventually sport a proven Yarvik released JB update.zip which you first need to load onto the internal SD memory but can then just use the inbuilt update function in the system tools.

When you connect to your PC via USB a notification states "Connected as an installer" as well as the usual "USB debugging connected and also "USB connected" thereafter as standard operation.

If anyone else should decide to give this ROM a fair trial I would like to hear your experiences.
As we all tend to use our tablets for own own specific purposes some ROMs may appear better than others.
I use my tablet for mostly streaming TVcatchup and playing Sentinal III and Asphalt 5 (I can get Ashalt 6 to run but it really is a bit too demanding of both my skills and the tablets's CPU.)

Note: This ROM link above is hosted on iDrive which does not allow simultaneous file download so if you can't get the file due to being busy downloaded by someone else, try again at a different time.
If it isn't broken then don't try to fix it!
User avatar
Trashcooky
Moderator
Moderator
 
Posts: 1672
Joined: January 4th, 2012, 8:52 pm
Location: South East England
Real Name: John
Scroll Version: Original Scroll Excel 2.3 now running Sugsy 89's 4..0.4 ICS
Tabtronics Mini 8" XGA 4:3 ration JB 4.2.2
Zopo C2 Platinum 4.2.1 - 480 ppi

Re: Yarvik Stock 4.0.4 for Excel - Discussion

Postby BORUSSIA70 » January 2nd, 2013, 5:48 pm

i like it and agree the JB CM10 numerous crashes etc,,, so loving the yarvik rom so far thanks for the heads up
BORUSSIA70
New Scroller
New Scroller
 
Posts: 5
Joined: November 22nd, 2012, 7:34 pm

Next

Return to Scroll EXCEL - General Discussions

Who is online

Users browsing this forum: No registered users and 1 guest

cron